I am pulling the bulb holders from a spare set of Euro front turn signal buckets to put in the open tailight spot in the rear. The holder came out easily once I found the holding clip, but for the life of me cannot remove the metal strip that contacts the bulb center pin. It wiggles but something is preventing it from coming out.
Any suggestions?
Taillight bulb holder removal.
Moderators: GRNSHRK, ron, bfons
Taillight bulb holder removal.
85 635CSi Bronzit
-
- Posts: 56
- Joined: Tue Feb 11, 2020 12:31 am
- Location: pensacola
Re: Taillight bulb holder removal.
I was just looking at mine 2 days ago. I think that elctrode is cast or glued to the plastic case. Probably easier to start over with universal bulb holder.
Re: Taillight bulb holder removal.
Thanks. It's just a small piece of brass that I could make from stock, but the existing hole just needs to be reamed out to fit a universal holder so I may just do that. Plus, I then have a set of functional Euro buckets as well. May just resilver those and run wires.
85 635CSi Bronzit
-
- Bigcoupe Contributor
- Posts: 323
- Joined: Wed Sep 10, 2014 12:08 am
- Location: Arden, NC 28704
Re: Taillight bulb holder removal.
I've added the additional brake lights. A universal bulb socket did not work out well for me. I proceeded to order BMW rear tail brake sockets from Ralph, with a little work they're in and looks as it came from the BMW factory as OE. Roger
89 635CSiA (11/88 build)
AlpineWeiss II (218)/Natur(0200)
87 L6 635CSI Sold
87 MB 560SL Sold
AlpineWeiss II (218)/Natur(0200)
87 L6 635CSI Sold
87 MB 560SL Sold